Yamaha CDC-685, 585 owner manual 828, You can select the same track again

8When you finish the programming for side A, program the pause mode by pressing the TAPE button.

TAPE

*“PAUSE” lights up in the display, and after then you can begin programming for side B.

9Repeat steps 5 and 6 to program more tracks for side B of the tape.

You can select the same track again.

*If “ERROR” appears in the display, the track number just selected cannot be programmed because there is no enough time remaining on side B of the tape.

Start recording on the tape deck and press the

wbutton at the same time.

The unit will pause at the end of side A of the tape. Turn the tape over to side B. Resume recording and, at the same time, press the w or

dbutton.

Notes

•In steps 7 and 9, even if “ERROR” appears in the display, you can program another track of which time is shorter than the remaining time on the side of the tape. At this time, if any other track number lights up in the display, you can program it.

•CD synchronized recording function can be used if your tape deck is compatible with it.

In this case, in steps 10 and 11, press the SYNCHRO button and then press the w button. Recording automatically begins. (For details, refer to page 16.)

Notes on tape programming

•To check, cancel or correct program data, refer to page

•The maximum number of tracks that can be programmed is 40. If, however, the PAUSE mode is inserted, it is counted as one track.

•This function can be used to program up to track number

20.If the disc has more than 20 tracks, tracks with track number 21 and higher cannot be programmed.

TRACK PROGRAMMING FOR RECORDING

■Display information during pro- gramming

1 2 3 4 5	PROG	1	2	3	4	5
		6	7	8	9	10

--A- 1

1

		2							4
1	2	3	4	5		PROG	1	2	3	4	5
							6	7	8	9	10
	4				-	8:28
						3

1Shows the side of the tape and the program number for the track to be programmed next.

2Shows the selected disc and track number.

3Shows the total remaining time on the side of the tape.

4 Programmed track numbers light up and programmable	FUNCTIONSFOR RECORDING
select button is pressed, the program number display can
track numbers among the unprogrammed ones blink.
* If “A-1” does not appear in the display after the PROG
button is pressed, press the TEXT/TIME display mode-
select button.
* If, during programming, the TEXT/TIME display mode-
be changed to display the total remaining time on the
side of the tape. To return to the previous display, press
the TEXT/TIME display mode-select button once again.

English

E-19