INSTALLATION INSTRUCTIONS
Drill the Holes
1.Locate the desired mounting location; position housing with camera pointed generally in the desired direction and mark location.
2.Use template to fix hole locations. Drill 4 holes for mounting screws (or anchors and insert plastic anchors into holes after drilling as required).
Mounting Steps
1.Use the security wrench provided to loosen the 4 screws holding the dome cover.
2.Remove the dome cover. (IF REAR WIRE MUST BE REMOVED/RELOCATED, SEE STEPS 4~8) Attach the camera body to the mounting surface with the mounting screws provided
3. Tighten the 4 mounting screws to secure the camera body to the mounting surface.
4.If you need to wire cable through side conduit hole, use a coin to remove the conduit plug; save the plug as it will be used to close the rear conduit hole.
Back conduit
hole
Conduit plug
Side conduit hole
4