3.Loosen the screws which lock the tilt mechanism. Rotate the pan and tilt mechanisms to point the camera in the desired direction. Rotate the camera module on its axis if necessary to align the image ‘upright’. Loosen the lens adjusting screws and adjust the lens to obtain the desired field of view and focus.
Tilt lock | Lens adjustment |
2 places
Focus adjustment
4.Lock the lens and tilt screws. Put the dome cover back and align the clear window in the dome cover with the lens. Attach the dome cover to dome base with the 4 mounting screws.
NOTE: The cover only goes on in ONE direction. There is a key and slot; if not aligned, cover will not close properly.
NOTE: If you move the camera module, it is necessary to loosen the dome and liner and reposition the liner so the lens points out through the slot, and the rubber seal presses onto the clear part of the dome and not the liner. Loosen 4 Philips screws, reposition liner, then TIGHTEN four cover attachement screws (else seal and vandal resistance is compromised).
6