EverFocus ED300 Series ? Camera Cover, ? Lens, ? Base, ? Focus Ring, ? Zoom Ring, ? Ground Pin

?Camera Cover

This cover will protect the camera from dust and damage.

?Lens

This Vari-Focal Lens allows users to adjust the Zoom and Focus manually.

?Base

The c amera unit is set in the dome base when it is shippED300 from the factory.

?Focus Ring

To set the focus, loosen the Focus ring knob first, then turn the ring toward < > or <N>

as necessary. When the focus is obtainED300 as desirED300, tighten the focus ring knob.

?Zoom Ring

Loosen the zoom ring knob, then you can adjust the viewing range. Turn the ring towards <W> for WIDE or <T> for TELE as

necessary. When the setting is finishED300, tighten the zoom ring knob.

?Auto Gain Control on/off switch.

The factory setting is AGC on.

?Back Light Compensation on/off

switch

The factory setting is BLC off.

?Level Volume Control

The iris level control for the lens.

?Ground Pin

For monitor use. Please see ?.

?Monitor Pin

When setting up the camera, connect a monitor to this video output pin and to the GROUND pin using alligator clip cables, then using the image displayED300 on the monitor, set the surveillance angle.

11 12 Power input

Use the connector to connect with 12VDC or 24VAC-power adaptor.

13Video Output BNC Connector

Use the connector to connect with the video in connector of a monitor.

6.