Yamaha TX-761DAB owner manual 26 En, Remote control

Troubleshooting

	Problem	Cause	Remedy	See
				page
	FM stereo reception is	The characteristics of FM stereo	Check the antenna connections.	8
	noisy.	broadcasts may cause this problem
			Try using a high-quality directional FM
		when the transmitter is too far away or		—
		the antenna input is poor.	antenna.
			Use the manual tuning method.	19
	There is distortion, and	There is multi-path interference.	Adjust the antenna position to eliminate
	clear reception cannot		multi-path interference.	—
	be obtained even with a
	good FM antenna.
FM	The desired station	The signal is too weak.	Use a high-quality directional FM antenna.	—
	cannot be tuned into
			Use the manual tuning method.
	with the automatic			22
	tuning method.
	Previously preset	This unit has been disconnected for a	Set preset stations.
	stations can no longer	long period.		21
	be tuned into.
	The Radio Data System	The Radio Data System information is
	information does not	not provided by the radio station.
	appear.
		The signal is too weak	Use a high-quality directional FM antenna	—
	The desired station	The signal is weak or the antenna	Tighten the AM loop antenna connections	—
	cannot be tuned into	connections are loose.	and orient it for the best reception.
	with the automatic
			Use the manual tuning method.	19
	tuning method.
AM
	There are continuous	Noise can result from lightning,	Use an outdoor antenna and a ground wire.
	crackling and hissing	fluorescent lamps, motors, thermostats	This will help somewhat, but it is difficult to	—
	noises.	and other electrical equipment.	eliminate all noise.
	There are buzzing and	A TV set is being used nearby.	Move this unit away from the TV set.	—
	whining noises.

■Remote control

Problem	Cause	Remedy	See
			page
The remote control does not	Wrong distance or angle.	The remote control functions within a	3
work nor function properly.		maximum range of 6 m and no more than
		30 degrees off-axis from the front panel.
	Direct sunlight or lighting (from an inverter	Reposition this unit.	—
	type of fluorescent lamp, etc.) is striking the
	remote control sensor of this unit.
	The batteries are weak.	Replace all batteries.	3
	Even if the remote control code is correctly
	set, there are some models that do not
	respond to the remote control.

26 En