Samson manual ARCHITECT’S & ENGINEER’S Specification, Servo 260 Specifications

ARCHITECT’S & ENGINEER’S

SPECIFICATION

The power amplifier, being of two channels, shall deliver a minimum of 90 W into loads of 8 ohms each with both channels operating, or 130 W into loads of 4 ohms each with both channels operating. It shall be passively cooled, and shall have internal short-circuit and thermal protection circuitry. A protection LED indicator shall acti- vate and the power amplifier shall shut down to protect against short circuits, overheating, severe overcurrent con- ditions or DC offset present at the outputs. The power amplifier shall have slow start-up and muted inputs on turn- on. Inputs shall be on balanced 1/4″ Tip-Ring-Sleeve con- nectors and outputs shall be on 1/4″ phone connectors and on push-spring terminals. The front panel shall have indepen- dent level controls for left and right channels, a master power switch and LED indicators for Clip, Idle and amplifier pro- tection.

The power amplifier shall have a frequency response of 20 Hz to 50 kHz, signal-to-noise equal to or greater than 103 dB and THD less than 0.03%. Total power consumed at full audio power shall be 490 W (115 Vac) and 490 W (230/240 Vac). The dimensions shall allow for standard 19″ EIA rack mounting. It shall be 3.5″ (88 mm; 2 rack spaces) high and 9.5″ (240 mm) deep. Weight shall be 17.6 lb. (8 kg). The power amplifier shall carry a three--year warranty.

The power amplifier shall be a SAMSON SERVO 260.

SERVO 260 SPECIFICATIONS

Rated Output Power (1 kHz):	130 W into 4 Ω		per channel
	90 W into 8 Ω		per channel
Signal-To-Noise Ratio:			103 dB
Frequency Response:		20	Hz to 50 kHz
THD+N, 20 Hz to 20 kHz:			< 0.03%
Input Sensitivity:	0 dBm to achieve rated power
	(Level control set to maximum)
Crosstalk (at 7 kHz sine wave):			85 dB typical
Power Requirements:		115 Vac • 50/60 Hz
Power Consumption (at full power):		490 W (115 Vac)
		490 W (230/240 Vac)
Dimensions:	3.5″	(h) x 19″ (w) x 9.5″ (d)
88 mm (h) x 482 mm (w) x 240 mm (d)
Weight:		17.6 lbs. • 8 kg

		FREQUENCY RESPONSE
0dB ref	AUDIO PRECISION Servo 260 LEVEL(dBr) & THD+N(x) vs FREQ(Hz)
5.0000							1.000
4.0000					Ap		.9000
3.0000							.8000
2.0000							.7000
1.0000							.6000
0.0							.5000
-1.000							.4000
-2.000							.3000
-3.000							.2000
-4.000							.1000
-5.000							0.0
10	100		1k	10k		50k

U® L

Specifications subject to change without notice. ©1998 Samson