Yamaha HTR-6090 owner manual 16 En, Conventional connection, Bi-amplification connection

CONNECTIONS

W

Using bi-amplification connections

Some of the speakers have speaker wire connections that allow bi-amplification to enhance the performance of the speaker system. This unit allows you to make bi- amplification connection to one speaker system. Check if your speakers support bi-amplification. As these speakers are shipped to you, you will note shorting bars or bridges, one connecting the two red input terminals and the other connecting the two black input terminals. Remove these shorting bars or bridges only if you plan to bi-amplify your speakers.

■Conventional connection

If you want to connect your speakers as traditional loudspeakers using the conventional connection method, connect your speakers using the regular left and right speaker wire connections and ignore the second set of terminals.

This unit

R + FRONT + L

		Right		Left
			Front speakers
Shorting bars or					Shorting bars or
	bridges				bridges

■Bi-amplification connection

To make the bi-amplification connections, use the FRONT and SURROUND BACK terminals as shown below. To activate the bi-amplification connections, set “BI-AMP” to “ON” in “ADVANCED SETUP” (see page 119).

This unit

+	SURROUND BACK/	+
	BI-AMP
		SINGLE
R +	FRONT	+ L

Right Left

Front speakers

Note

Remove the shorting bars or bridges to separate the LPF (low pass filter) and HPF (high pass filter) crossovers.

16 En