Solution
■ Make sure the battery is charged and installed correctly (see page 1).
■ Adjust the LCD Brightness setting (see page 30).
■ Continue taking pictures. The camera is operating normally.
(The camera estimates the number of pictures remaining after each picture is taken, based on picture size and content.)
■ Check the flash setting, and change as needed (see page 8). NOTE: The flash does not fire in all modes.
■ Transfer the pictures to the computer (see page 32).
■ Delete pictures from the card (see page 18) or insert a new card.
■ Card may be corrupted. Format the card in the camera (see page 31).
■ Use another memory card. Only SD or SDHC Cards are supported.
■ Verify that the correct battery type is installed (see page 44).
■ Wipe the battery contacts with a clean, dry cloth before inserting it in the camera.
■ Insert a new/charged battery (see page 1).
■ Limit the time you review pictures/videos on the camera LCD. ■ Purchase batteries at www.kodak.com/go/accessories.
www.kodak.com/go/support
Troubleshooting
Troubleshooting
Camera problems
Status
Camera does not turn on
Camera does not turn off
Camera buttons and controls do not function
LCD is too dark.
Pictures remaining number does not decrease after taking a picture
Flash does not fire
Memory card is almost or entirely full
Memory card not recognized or camera freezes with card
Battery life is short
36