Getting Started
Important
ŸIn the event of malfunction or damage, it is possible that data may be lost. Konica can not accept responsibility in any way for such data loss.
ŸAlways
ŸWhen using SD Memory Cards on a PC, do not change the
ŸDo not change the file names or the directory name of image data saved on an SD Memory Card using a PC or save files other than image data taken by this camera. Images that have been changed or added will not only not play back on the camera but may cause the camera to malfunction as well.
ŸAlways format SD Memory Cards using this camera. A card formatted in a PC may not operate properly.
ŸThe SD Memory Card includes a
Sliding this switch downward prevents data from being written to the card and images, etc. saved on the card are protected. Please note that pictures cannot be taken or deleted when the writeprotect switch is on.
ŸWhen using a
Attaching the Wrist Strap
20
| Getting Started |
|
|
|
|
| Basic Photography |
1 | .Open the lens cover. |
2 | .Switch on the power. |
3 | .Set the Mode Dial to Shooting Mode ( ) for still image or Movie Clip |
| Mode ( ) for video recording. |
4 | .The setting of the focus range for still image capture is required as follows |
| Macro ( ) : 0.2m |
| Normal ( ): 0.8m~infinity |
5 | .Refer to the next section |
| up the features you prefer. |
6 | .Hold still and press down the Shutter Button. |
7 | .The LED Indicator starts blinking right after the Shutter Button is released. |
8 | .Once the LED Indicator stops blinking, you are ready to take another shot. |
Note
A message of "LENS COVER" blinking on the TFT LCD Monitor as a warning is to remind you to open the lens cover first.
Note
Amessage of "Low Light!" appearing on the TFT LCD Monitor as a warning is to remind you that the image that you are going to capture is under a low light environment. To compose a good quality image, it is strongly recommended to go to the Flash Mode to select Auto Flash or
21