Mamiya C330S: Page 20
Distance Scale (cont.) | 20 |
Replacing the Distance Scale
To remove the distance scale, first, fully extend the bellow by turning the focusing knob, then remove the scale end cover by sliding it to the front. Next, detach the distance scale from the bearing, while pressing in the distance scale shaft with a pointed, fine wire.
When installing the distance scale, insert the shaft end opposite the revolving knob into the camera body bearing. Insert the shaft end while pressing the spring located near the bearing to the inner side with the side of the scale. Next, fit the shaft to the front bearing while pushing in the shaft tip with a finger nail; then install the cover as it originally was.
<- Prev Table of Contents Next
file:///E/c330s/page_20.html