Mamiya 645 AFD III manual Self Timer Mode

Page 40

Self Timer Mode

Long Exposure Mode (Bulb Mode) / Backlight Button

With this function, under the default setting the shutter is released 10 seconds after the shutter release button is pressed. The self timer lamp flashes slowly for the first 7 seconds, then flashes quickly for the last 3 seconds before the shutter is released. Use this function to take group photos or to photograph yourself.

Long Exposure Mode (Bulb Mode)

To expose film longer than 30 seconds, adjust the shutter speed to “B” (bulb). In order to prevent camera shake, use an electromagnetic shutter release and tripod.

F

 

C X

M

 

Tv

P

Av

 

1. Mount the camera to a tripod.

2. Turn the shutter release mode selector to the

“ ” (self timer mode) position.

3. Turn the front dial, and set the self-timer mode

to ON.

4. Check the view by looking through the

viewfinder. Make sure that the focus is correct,

 

 

 

CF

P

 

A

X

 

v

TM

 

 

v

1.While pressing the unlock button, turn the ex- posure mode dial and set it to “M” (manual mode).

2.Turn the front dial to select “bulb”, then turn the rear dial to set the aperture.

3.Determine the composition, focus, then take the picture. The shutter remains open as long as the shutter release button is pressed.

press the shutter release button and the shut-

ter will be released after 10 seconds.

★As the camera is electronically controlled even during exposures, it is recommended to replace batteries before bulb exposure. (See page 11.)

Change the self timer time

1. Normally the camera can take a picture with a bulb shot up to 60 minutes. However, the bulb shot time can be changed from one minute

F

 

C X

M

 

Tv

P

Av

 

1.Press the self timer button to set the self timer mode.

2.Turn the rear dial, and change the operating time. It can be set from 2 to 10 seconds in units of 1 second and for more than 10 seconds in

10second units.

to infinity. Custom settings (C-21 on page 95)

2.It is possible to set the camera so the shutter remains open until the

button is pressed once again. Custom settings (C-22 on page 95)

Backlight Button

To see the main panel at night or in dark places, press the backlight button A/.

The backlight will go on approximately 10 sec- onds and go off unless there is another opera- tion.

Releasing self timer mode

1.Press the self-timer button to set self timer mode.

2.Turn the front dial to "OF."

★To release the self timer while it is operating, turn off the power (by setting the drive dial to "L").

★When there is bright light source behind the camera or when you press the shutter button without looking through the viewfinder, light may enter from the viewfinder's eyepiece, adversely affecting the exposure metering. Turn the eyepiece shutter open/ close knob to close the eyepiece shutter, then take the pictures. (page 75.)

★When releasing the shutter, or pressing the backlight button A/ while the backlight is on, the backlight will go OFF.

★When operating the camera while the backlight is on, the backlight will light on for approximately another 10 seconds.

The backlight can be set to turn on during the camera’s metering

retention period. Custom settings (C-06 on page 93)

77

 

78

 

Page 39 Page 41
Image 40
Page 39 Page 41
Contents
Instructions Special Advice To Professional Photographers PrefaceNames of Parts and Functions Liquid Crystal Displays LCD Main LCDViewfinder LCD Electronic Dial OperationCustom Functions 90 to ContentMiscellaneous Operations 98 to110 Set the auto focus mode selec- tor lever to S. See Camera Operation TestChecking the Battery Power Alkaline batteryInserting the Batteries without batteries Camera will not operateInstalling the Battery in the Magazine Battery Power / Battery CareRemove the battery compartment screw cap Insert a batteryAttaching and Removing a Lens Attaching the lensBefore installation Shutter Safety RetractionInstallation and removal of the magazine and its dark slide Attaching / Detaching a MagazineReplacing the Diopter Correction Lens Diopter AdjustmentDiopter not matching.Diopter matching How to imprint the same index number Setting the Index NumberDial Setting Date and Time Setting Date and Time / StrapBasic Operation Setting the Film Speed Attaching a Lens and a MagazineAttaching a Lens Attaching a MagazineLoading Film in the Magazine Attach the leader paper of the film to the empty spool Close the back coverInsert the loaded film insert into the magazine Film.Selecting the Shooting Frame Number Display Compatibility between the HM402 and HM401 120/220 magazinesCamera Magazine BodyTaking Photos in the Fully Automatic Mode Set the focus mode selector lever to S single focus modeMode setting and a C continuous advance Mode setting. SeeShutter Release Button / Holding the Camera FocusShutter Release Button Holding the CameraRemoving a Partially Exposed Roll of Film Unloading the exposed filmElectrical Contacts This chapter describes various functions of the cameraSingle focus mode S Focus Area Continuous focus mode CFocus Modes Focus AreaLenses with the Focus Mode Selector Manual Focus ModeManual Focus Mode M Manual focusing using the focus mark When Auto Focus FailsMals in cages, etc Subjects with continuous re Using the Focus Lock Function Set the focus mode selector lever to S or CAdjust the composition AF Assist Infrared LightSingle-Frame Mode Self-Timer ModeContinuous Mode Drive ModesExposure Modes Program AE PProgram Shift PH/PL Normal Program shift areaAperture Priority AE Av Custom settings C-01 onShutter Priority AE Tv Manual Mode M Turn the front dial to set the desired shutterSpeed ±6 EVCF Custom Function Mode CF ModeOne-push shift function Selected aperture value can be locked. SeeHow to select an exposure mode Exposure Metering ModesExposure Metering Modes Exposure warningsDisplay of the exposure compensation of the viewfinder LCD Exposure CompensationWidth of the exposure compensation step can be changed AE Lock Mode Metered-value difference indicatorMargin Auto-Bracketing ModeNormal exposure Under exposure Multiple Exposure Mode AE settings under auto-bracketing mode Single-Frame Mode S Continuous Mode CTo cancel the Multiple Exposure Mode Press the shutter release buttonCelled Exposure compensation in typical multiple exposuresTaking Photos with the Mirror Up Using auto focus and auto exposure Manual modeHalfway while looking into the view finder Selecting the Number of Frames to be Shot Electronic Shutter Release Contact / Eyepiece ShutterElectronic Shutter Release Contact Eyepiece ShutterSelf Timer Mode Front / Rear Dial Lock Function Depth of Field / Depth of Field PreviewInfrared Photography Flash PhotographyMetz Flash SCA3952 System Functions Rear Curtain Sync ModeFor example External LCD Panel normal display Flash Compensation SettingsViewfinder LCD read-outs Selected shutter speed and aperture level can be locked See Superimposing DataThis camera’s synchro contact is an X contact Custom Functions Setting Custom Functions Custom Functions of Mamiya 645AFDTypes of Custom Functions AFL function lock mode Mode one-push settingBulb exposure time setting Bulb shutter release settingMiscellaneous Operations Changing the Focusing Screen Using the M645 Manual Focus Lenses External Battery SocketAvailable functions with M645 lens Half press the shutter release button to show shutter speedTripod / Memo Clip Using a TripodMemo Clip When Any of These Displays Appear Specifications Field of View 94%* of actual image Viewfinder InformationMaintenance and check of the camera Importance of Proper MaintenanceCommon Sense Camera Care and Practice After-Sale Servicing
Top Page Image Contents