Tekxon Technology MegaCam manual Preparing Your Camera, Start Using Your Camera

Preparing Your Camera

•Step 1 Insert the two AA batteries into the battery compartment located at the bottom of your digital camera. When closing the battery door, push the battery door down and then slide it closed.

•Step 2 Open the memory compartment cover located at the bottom of your camera and insert the SD memory card.

Note: 1. To remove the SD card, push the SD card once and the card will be ejected from the memory compartment.

2.MegaCam comes with built-in 8Mbyte internal NAND Flash memory. You don’t necessarily add extra memory for it.

•Step 3 Attach the wrist strap to the strap holder at the side of the camera as illustrated in the picture below.

When inserting, hold the memory card so that its pin connector is pointing towards the camera. Also, the front side of the memory card should be facing the front side of the camera.

Then, push the memory card all the way into the memory compartment and close the cover.

Start Using Your Camera

•Step 1 Press the Power button to turn on the camera. A green light just beside the Viewfinder then lights up.

•Step 2 The LCD Display will be turned on automatically.

7