Tips for locating your camera

You should position your cameras to cover the areas most exposed to risk. See our suggestions below for some ideas:

1. Doorways

2. Windows

3. Car Parks

4. Verandahs

5. Reception	6. Cash	7. Mix
areas	register	dummies
		& real
		cameras

Where to Place The Security Stickers:

1.On your front window

2.On side windows

3.Near entrance points - doors, gates

4.Next to a dummy camera mounted outside

5.On the front counter

6.On the cash register

7.Next to an obvious camera

Connect the camera to your monitoring device

These step by step instructions are provided for you to enable a quick and simple installation of your camera. Please refer to the diagram over the page for component identification details.

Step 1: At the end of your Maxi-Brite Camera cable you will find two plugs: •Video BNC Female Connector (1a)

•DC Power Socket (1b)

Step 2: Plug the BNC Female (1a) into the BNC Male Connector (3a) on the extension cable and turn the outer ring to lock the connectors. Plug the BNC to RCA Adaptor (4) into the other BNC Male Connector (3b) at the other end of the extension cable and then into the RCA Video In socket on your TV or VCR (usually located at the back). This is the best method of connecting the camera initially to test it for correct operation.

Step 3: Connect the DC Power Plug (2a) at the end of the power adaptor (2) into the DC Power Jack (3c) on the extension cable, and plug DC power plug (3d) into your Maxi-Brite Camera’s DC Socket (1b).

Step 4: Plug the power adaptor (2) into the mains power point on your wall and switch on.

Step 5: If you have an A/V TV with RCA sockets you will need to switch the TV to the AV channel to view the camera.

To view the camera connected to your VCR, you will need to select the AV input you have connected the camera to on the VCR, turn your TV onto the channel you would normally use to view a tape or movie on your VCR. This channel may be activated by a button on your remote that is marked with this symbol , or L1 or L2 or possibly AV1 or AV2 . Please read the instructions for your VCR or TV for more information on using their A/V inputs.

Note: The Maxi-Brite Camera will automatically change to a black & white image using the Infra-Red LEDs when available light is too low to support a clear color picture.

NOTE:

All jurisdictions have specific laws and regulations relating to the use of cameras. Before using any camera for any purpose, it is the buyer’s responsibility to be aware of all applicable laws and regulations that prohibit or limit the use of cameras and to comply with the applicable laws and regulations.

The legality of watching people other than yourself changes from country to country and even state to state. Contact your local government's privacy information body or your local Police for more information on what if any restrictions you may face.