Introduction, Compatibility, Package Contents

Introduction

Congratulations on your purchase of this Swann PTZ Camera!

This installation and setup guide will walk you through the basics of connecting the PTZ camera to your DVR, and walk you through the settings on the DVR you’ll need to use to control the camera.

Be aware that the camera must be connected to a compatible DVR to operate

correctly.

The included stand-alone RS485 controller will operate the basic features of the camera, and access the on-screen display (OSD). You won’t be able to program the camera properly or integrate it’s functions with your system unless your DVR is configured to do so.

Compatibility

This Swann PTZ camera is compatible with most current Swann DVRs. We can confirm that it will work with the following DVR models:

1200, 1300, 2500, 2550, 2600, 3000 and 4000 series DVRs.

This is not an exhaustive list - since the time of publication we may have released newer DVRs with which this camera is compatible. Check your DVR documentation to learn more. Any Swann DVR with an RS485 port should be compatible with this camera.

IMPORTANT: If mounting the camera outside, be sure to properly seal all joints in the mounting arm/bracket using a silicon sealant. If this is not fully sealed, water can enter the dome causing malfunction or failure.

Package Contents

PRO-752 Camera

RS485 Controller

Camera Cable

Extension Cable

Screws and Mounting Hardware

Power Supply (not pictured)

Power Splitter (not pictured)