Swann SW244-AUO manual Mountingthecameraonyourwallorceiling

How￿to￿connect￿Outdoorcam￿camera￿to￿your￿TV￿or￿VCR

Step￿1: At￿the￿end￿of￿your￿Outdoorcam￿camera￿cable￿you￿will￿find￿two￿colored￿plugs:

•Yellow￿(Video￿RCA)

•Black￿(DC￿Power)

Step￿2: Plug￿the yellow RCA￿plug￿(1)￿into￿the "Video￿In" input￿(2)￿(usually￿located￿at￿the￿back￿of￿your￿TV or￿VCR).

Step￿3: Connect￿the black plug￿(3)￿at￿the￿end￿of￿your￿Outdoorcam￿camera￿into￿the black plug￿at￿the￿end of￿the power￿adaptor (4).

Step￿4: Plug￿the power￿adaptor (5)￿into￿the￿mains￿power￿point￿in￿your￿wall.

Step￿5: If￿you￿have￿an A/V￿TV with￿RCA￿sockets￿you￿will￿need￿to￿switch￿the TV to￿the AV channel￿on your TV to￿view￿the￿camera.￿To￿connect￿the￿Outdoorcam￿camera￿to￿your VCR,￿you￿will￿need￿to turn￿the VCR to￿the A/V￿Input selection￿and￿turn￿your TV onto￿the￿channel￿you￿would￿normally use￿to￿view￿a￿tape￿or￿movie￿on￿your VCR.￿This￿channel￿may￿be￿activated￿by￿a￿button￿on￿your remote￿that￿is￿marked￿with￿this￿symbol￿￿￿￿￿￿￿,￿or L1 or L2 or￿possibly AV1 or AV2.

Note: The￿Outdoorcam￿will￿automatically￿turn￿on￿the￿Infra-Red￿LEDs￿when￿available￿light￿is￿too￿low￿to support￿a￿clear￿picture.

Note: Please￿read￿the instructions for￿your VCR or TV for￿more￿information￿on￿using￿their

A/V￿inputs.

Mounting￿the￿camera￿on￿your￿wall￿or￿ceiling

1.Once￿you￿have￿chosen￿the￿best￿position￿for￿the￿camera,￿switch￿the￿power￿to￿the camera￿off,￿and￿unplug￿the￿power￿lead￿from￿the￿camera.

2.When￿mounting￿the￿Outdoorcam￿camera￿to￿your￿ceiling￿or￿wall,￿please￿ensure￿that

you￿rotate￿the￿camera￿so￿that￿￿at￿the￿top￿of￿the￿camera￿lens￿is ‘up’,￿otherwise￿you￿will find￿that￿your￿pictures￿are￿displayed￿upside￿down.￿(see￿diagram)

3.Hold￿the￿camera￿base￿in￿the￿position￿you￿wish￿to￿fix￿it,￿and￿mark￿the￿holes￿with￿an appropriate￿pen￿or￿pencil.￿Once￿this￿is￿done,￿remove￿the￿stand￿and￿drill￿a￿hole￿with the￿appropriate￿drill￿bit￿for￿the￿material￿you￿are￿mounting￿your￿camera￿to￿and￿the screws￿or￿fasteners￿you￿are￿using.

4.Run￿the￿camera￿cable￿back￿to￿the￿TV/VCR,￿any￿holes￿that￿you￿drill￿need￿to￿be￿at￿least 9/16” (14mm)￿in￿diameter￿to￿allow￿the￿connectors￿to￿pass￿through.

5.Reconnect￿the￿power￿lead￿to￿the￿camera￿and￿switch￿the￿camera￿power￿back￿on.

6.Position￿the￿camera￿and￿firmly￿lock￿the￿stand￿into￿place.￿Do￿not￿over￿tighten￿or forcefully￿adjust￿the￿camera￿once￿it￿has￿been￿correctly￿positioned.

3