Snapper EMRP216518B PRE-START Check List, Starting & Operation 2.2.1. Engine & Blade

Page 7

Section 2 - OPERATING INSTRUCTIONS

2.1PRE-START CHECK LIST

Make the following checks and perform the service required before each start-up.

2.1.1.Check guards, deflectors, grass bag, adapter and covers to make sure all are in place and securely tightened.

2.1.2.Check blade control and wheel drive control to insure they work freely. See Figure 2.1.

BLADE

CONTROL

WHEEL DRIVE

CONTROL

FIGURE 2.1

2.1.3.Check cutting height. Adjust to desired height. Refer to Section “CUTTING HEIGHT ADJUSTMENT”.

2.1.4.Check engine oil and add oil as needed to bring level up to the full mark. Refer to Engine Owner’s Manual for oil specifications. See Figure 2.2.

2.1.6.Clean exterior surfaces of cutting deck and engine of any accumulation of spilled fuel, dirt, grass, oil, etc. Keep engine air intake screen and cooling fins clear at all times.

2.2STARTING & OPERATION 2.2.1. ENGINE & BLADE

1.Push primer bulb three times to start a cold engine. NOTE: Primer should not be required to restart a warm engine. See Figure 2.3.

PRIMER BUTTON (PUSH 3X)

FIGURE 2.3

3.Pull blade control against handle. See Figure

4.Pull rope start handle to crank engine.

BLADE

CONTROL

ROPE

START

HANDLE

FIGURE 2.2

FIGURE 2.4

2.1.5.Add fuel to tank after pushing the mower outside where fumes can safely dissipate. Make sure cap is tightened after refueling. Refer to Engine Owners Manual for specifications.

5.After engine starts, allow a brief warm-up until engine runs smooth.

NOTE: Stop the engine (and blade) by releasing the blade control.

7

Image 7
Contents Model Designation Recycling Model Briggs & Stratton 65 6.5 HP Engine Horse PowerEuropean Model Series DesignationImportant Safety Instructions Do not refuel the machine indoors From PreviousImportant Safety Instructions Table of Contents Nomenclature IntroductionStarting & Operation 2.2.1. Engine & Blade PRE-START Check ListStopping Cutting Height AdjustmentHandle Height Adjustment Propelling MowerSecure Adapter To Deck with Nuts Connector Adapter Flange Nuts Important Drain fuel tank before tipping mower Service After First 5 Hours 3.2.1. Change Engine OILOn Next Check Engine Drive Belt Service AnnuallyStorage Procedure Check Mower BladeBlade Sharpening Mower Blade Replacement 4.1.1. Standard Blade Wear Limit1.A. Ninja Blade Wear Limit Wheel Drive Control Adjustment Driven Disc Adjustment Driven and Drive Disc ServiceCleaning Drive Disc & Driven Disc Drive Spring Repair/ReplacementReplacing Rubber Driven Disc Drive Disc Assembly Install NEW Driven Disc Snap Rings Belt Service Pulley Position Corrective Action Problem Probable Cause2119 100 Service Performed EachClean Sponge Element Engine Manual MAINTENANCE/REPLACEMENT PartsDecal Identification European Performance 253 Disclaimer of Warranty264 275 286 European Steel Deck Walk Behind Mowers Type ‘M’ Series