Camera Setup, Set Date and Year | Tasco 119223C specification

CAMERA SETUP

Open the Cam by pulling out on the two latches on the right side. Install 4 “C” cell batteries (flat base of all batteries contacting springs), and insert an SD card (not included, use any capacity from 16MB to 8GB. Do not substitute MMC cards.) in the slot to the right of the 5 buttons as indicated on the slot cover (upside down, with the notched corner of the card on the left and metal contacts of the card facing the back of the slot). Press the card down until you hear it click into place. If the Cam is turned on without a card in place, it may not turn off-reset it by pulling one of the batteries out partway, insert a new or empty SD card, and put the battery back in place. Only remove or insert cards with power off.

1. Date

2. Time

3. 4 Digit Display

4. Still Photo Mode /

Resolution

5. Video Mode

6. SD Card

Setup Icons- Display Guide

1. Setting the Date, Year and Time

If you are using the camera for the first time, you should set the date and time so your photos will be “stamped” correctly.

Set Date and Year

•Briefly press the MENU button-the first two digits of the year will flash, prompting you to enter the year.

•Use the UP/DOWN buttons to set the current year (2010-2030), then press OK. Set the month the same way, and press OK again.

•Set the month the same way, and press OK again. The display will then change to let you set the day, with only the last two digits blinking.