Jenoptik 10.0Z3 manual File Naming, Setting the TV OUT, Setting USB Port, Choosing a Startup Image

ADVANCE SETTINGS

File Naming

File name are followed by a 4-digit number that increases in sequence. File numbering starts from 0001 when a new folder is created.

If the highest folder number is 999 and highest file number exceeds 9999, the camera will display the warning message “Folder cannot be created”. When it appears, try one of the following ways:

•Reset the file number and plug in a new memory card.

•Format the memory. The folder number and file number are initialized and renumbered from 100 and 0001 respectively.

Note: Do not change the folder and file names in the memory card using your computer. It may be unable to playback the data using the digital camera.

SETTING THE TV OUT

Your camera can be connected to a TV allowing you to preview images and movie clips on the television screen. TV Out should be set to either NTSC or PAL depending on your region.

Option	Description
NTSC	America, Japan, Taiwan, Korea
PAL	All of Europe

SETTING USB PORT

You can set USB mode to connect the camera with a printer or computer.

Option	Description
Computer	To connect your camera to a PC.
Printer	To connect your camera to a printer.

CHOOSING A STARTUP IMAGE

You can choose a recorded image as the start-up image.

1.Set the camera to the Playback mode.

2.Press or to select a desired image.

3.Press the MENU button, then press or to select S.IMAGE

( ).

4.Press or to select an option, and then press the SET button.

5.Set the camera to the Setup Menu .

6.Press or to select S.IMAGE ( ) then press or the SET button.

7.Press or to select a desired image and press the SET or the MENU button to apply the setting.

8.Press the MENU button to close the menu.

Note: The start-up image will not be deleted even if the original image is deleted or memory formatted.

27