Q-See QT19DVR8C manual To Record With Your DVR, To Set Up Motion Detection Recording

To Record With Your DVR:

There are 3 modes for recording:

1.Manual recording: Push the RECORD button. It will record all the time until you stop it by pushing the RECORD button again.

2.Motion Detection Recording: This will record only when there is a Motion in front of the camera.

3.Time Schedule Recording: Use this option to record during specific times.

To Set Up Motion Detection Recording:

Use the remote control and push MENU, the default password is 88888888 then follow the instructions below:

Go to DETECT and push MENU to enter Motion setup

Use the Down arrow to get to the second button which is the

RECORD button and push MENU to enter.

In the Motion Setup screen, we need to setup CH 1 through 8
or whatever channel we want to enable motion detection like
in the above picture.
Then go to Detect Area and select SET ALL and push MENU to
enter the area and you will see an all screen purple (right
picture)	Then you need to push 0 (number 0) on remote control to
	exit the area. And use LEFT Arrow to exit all the way out of
	the menus.

The system will start recording when there is motion and a Blue Round ball will come up where a camera is detecting motion.