Q-See QSTD manual Setting UP DMZ in Router

Page 6

SECTION 4: SETTING UP DMZ IN ROUTER 2

NOTE! You will only need to proceed with this section if you detected a second router in Section 2.

STEP 1. Login into Router 1 by putting the IP of Router 1 into the Internet Explorer browser, as in the example shown in Picture 23 where the IP address of Router 1 is 192.168.0.1

STEP 2. Find the status page on the router settings that shows the WAN/ Internet IP address and write it down this WAN IP address.

STEP 3. Log into the Router 2 by putting

the IP of Router 2 into the Internet Explorer browser, as in example shown in Picture 23 where the IP address of Router 2 is 192.168.1.1

STEP 4. Find the DMZ page in the router

settings.

 

STEP 5. Enter the WAN IP for Router 1

 

into the DMZ page and enable DMZ.

PICTURE 23

 

NOTE! If you do not have a DMZ setting in the router, check to see if there is a Bridge setting. If so, then use the Bridge setting instead of DMZ.

STEP 6. Save your changes.

You have forwarded the ports on the router to which the DVR is connected, to the IP address of the DVR, and set the primary router to pass the connection to this router.

Image 6
Contents Qstd Series Port Forwarding Instructions Determining the IP Address of DVRDetermine the Number of Routers on the Network Go toDownload Simple Port Forwarding Program If Multiple Routers are DetectedClick on ADD Custom Windows Mobile Setting UP DMZ in Router