Yamaha NS-P110  Automatic power-switching function,  Adjusting the subwoofer before use

Page 14

Automatic power-switching function

If the source being played is stopped and the input signal is cut off for 7 to 8 minutes, the subwoofer automatically switches to the standby mode. (When the subwoofer switches to the standby mode by the automatic power- switching function, the power indicator lights up in red.) When you play a source again, the power of the subwoofer turns on automatically by sensing audio signals input to the subwoofer.

This function will operate by sensing a certain level of low frequency input signal. Usually set the AUTO STANDBY switch to the LOW position. However, if the power is not switched on or to the standby mode smoothly, set the switch to the HIGH position. In the HIGH position, the power will turn on even with a low level of input signal. But please be aware that the subwoofer may not switch to the standby mode when there is an extremely low input signal.

*The power might turn on unexpectedly by sensing noise from other appliances. If that occurs, set the AUTO STANDBY switch to the OFF position and use the POWER switch to switch the power between ON and OFF manually.

*This function detects the low-frequency components below 200 Hz of the input signals (i.e., the explosion in the action movie, the sound of the bass guitar or the bass drum, etc.).

*The minutes required to switch the subwoofer to the standby mode might change by sensing noise from other appliances.

This function is available only when the power of the subwoofer is on (by pressing the POWER switch).

Adjusting the subwoofer before use

Before using the subwoofer, adjust the subwoofer to obtain the optimum volume balance between the subwoofer and the front

speakers by following the procedures described below.

Rear panel

3

POWER

ON

OFF

VOLUME

0

10

AUTO

 

STANDBY

 

HIGH

 

LOW

 

OFF

 

INPUT

/MONO

POWER

ON

 

OFF

 

VOLUME

1, 5

0

10

AUTO

 

STANDBY

 

 

 

 

HIGH

 

 

 

LOW

 

 

 

OFF

 

 

 

INPUT

/MONO

E-10

Image 14
Contents NS-P110 NS-P116 Important Safety Instructions We Want You Listening For a Lifetime FCC Information for US customers only4m10m For SW-P130 Components of the Package Rear center speaker for NS-P116 Subwoofer Rear L Rear centerFor NS-P116 Use the nonskid pads  Placing the subwoofer Placing the center speaker Using the Yamaha Speaker Stand SPS-80 option Mounting bracket AAX34790 Screw AAX12390 NS-P110 NS-P116 Connections  An example of basic connectionsHow to Connect  How to connect speaker cablesBefore connecting Volume control Power switchAuto Standby HIGH/LOW/OFF switch  Controls and their functions Automatic power-switching function  Adjusting the subwoofer before use Frequency characteristics Shows the frequency characteristics of the subwooferAdvanced Yamaha Active Servo Technology for SW-P130 Though the Power switch is set Problem Cause What to Do No soundProblem Cause What to Do Power is not supplied even Standby mode automatically NX-E130, NX-C130  SW-P130WF51940