6 Back focus adjustment
The back focus screw is an ‘endless’ screw that turns the back focus ring.Turning the screw in either direction will move the sensor chip back and forth from C mount position to CS mount position.
C - CS
Mount
LENS | Digital Camera |
7 Electrical Connections
7.1 AC MAINS POWER SUPPLY
Mains voltage models:
LTC0600/50 PAL
LTC0600/60 NTSC
Power cable & inner conductors
Camera models /50 are fitted with 2 wire power cable with Euro plug.
•Brown: Live, Reference line lock
•Blue: Neutral
English
Mode LVL BLC
AWB LL Phase
BAC
A:Back Focus (Fine adjustment)
B:CS Mount, (Turn till focus)
C:C Mount, (Turn till focus)
Instructions for back focus adjustment:
1.Set the lens distance to infinity.
2.Switch on the power supply to the camera, and switch on your monitor.
3.Aim the camera at an object which is over 15 meters away.
4.Adjust the back focus by turning the screw until the picture on the monitor is sharp.
Note: This adjustment is most accurate with the iris fully open.
Camera models /60 are provided with 2 wire power cable with polarized US plug.
•Black: Live, Reference line lock
•White: Neutral.
Voltage Range: rated
Power dissipation: <8 W.
7.2 LOW VOLTAGE AC/DC INPUT TERMINAL
Low voltage models:
LTC0600/10 PAL
LTC0600/20 NTSC
Camera models
output terminals.
24 V AC Power Supply
Connect the 24 V AC wires to the camera- input terminal.
•Pin 1: Live, Reference line lock
•Pin 2: Neutral
Voltage Range: rated
Power dissipation: <8 W.
12 V DC Power Supply
Connect the 12 V DC wires to the camera- input terminal. The supply connection is polarity independent.
Voltage range rated: 11 – 36 V DC
Power dissipation: <8 W.
SyncBalance Video
RS232
Mains voltage models: LTC0600/50 PAL LTC0600/60 NTSC
SyncBalance Video
RS232
1 2
Low voltage models: LTC0600/10 PAL LTC0600/20 NTSC
Low Voltage connector
polarity independent
| 1 | 2 | |
| + | - | |
| - | + | |
lock | ~ | ~ | |
24 V AC | |||
Line | |||
12 V DC | |||
Ref | |||
|
| ||
10
11