WebCam settings Chapter
EN
4Full automatic control:on/off
This full automatic control mode provides a very easy way to get the best out of your Philips SPC1300NC WebCam.
Or you can choose to have maximum manual control over the WebCam settings by switching the full automatic control mode off. Full automatic control 'on' is the preferred setting for normal use.
Techniques active within full automatic control mode are:
–Automatic exposure control and automatic white balance control, to provide the best video source signal possible;
–Automatic frame rate selection for improved WebCam sensitivity in low light conditions.
5Frame rate
You can use the scroll open menu to set the frame rate of the video you wish to capture. E.g. 30 fps means that the WebCam will capture video at 30 frames per second.
6Auto Exposure
The exposure is the amount of light received by the sensor and is determined by how long the sensor is exposed to capture a snapshot or video frame.The result depends on the sensitivity of the sensor.The WebCam will find the optimal setting if you select the automatic exposure option.
Shutter speed
The shutter speed determines how long the camera shutter remains open as a picture is taken.The slower the shutter speed, the longer the exposure time.The shutter speed controls the total amount of light reaching the sensor.
Use the slider to set the desired shutter speed. Gain
In video, gain is the amount of white in a video picture. Use the slider to set the desired gain level.
7Reset
Press this button if you would like to reset the WebCam settings to the default factory settings.
8Restore
Press this button if you would like to restore your personal preferred settings.
9Save
Press this button if you would like to save your personal preferred settings.
13