PARTS NAMES
|
| 1 Video output connector (VIDEO OUT: BNC type) | |
|
| Connect this connector to a device such as a VCR or monitor with a VIDEO IN connector. | |
1 | 4 | 2 Line phase adjustment volume (LINE PHASE) | |
| When using two cameras or more, the image on the monitor may roll vertically when switching sources. This | ||
|
| ||
| 3 | rolling can be minimized by turning this volume. | |
2 |
| 3 External sync composite video signal input connector | |
5 | (VS IN: BNC type) | ||
|
Connect to this connector the synchronizing signal output from a synchronizing signal device or the composite signal of a video distributor.
4Power indicator (POWER)
Comes on when the power to the camera is on.
524 V AC input terminal (24 V AC, GND)
Connect to 24 V AC UL listed class 2 power supply.
6
6 Camera setup section (under the cover)
These settings are for when using a 1/3 inch CS mount DC (without EE internal amplifier) type lens. However,
7if due to installation conditions or environment the settings may need to be modified for best results (see
1 | 3 | "SETTINGS"). | |
To access the controls, loosen the cover fixing screw A, then remove the cover. | |||
A |
| ||
|
|
7 Lens iris output connector (LENS)
24 This