Sanyo Security Camera Installation, See Figure, Hard Ceiling Mounting, On back cover

5 INSTALLATION

Attention: Installation should be performed by qualified service personnel only, in accordance with the National Electrical Code or applica- ble local codes. Refer to applicable installation section.

5.1Suspended Ceiling Mounting CAUTION:These units must be properly and securely mounted to a supporting structure capable of sustaining the unit weight. Use care when selecting mounting hardware (not sup- plied) for installation.The mounting surface and unit's weight should be carefully considered.

Mount the unit in a suspended ceiling grid using the existing ceiling tile as follows:

1.Remove tile at desired location.

2.Cut a 172 mm (6.75-inch) diameter hole in the center of the tile. Use two pencils (or a pencil and a nail) with the template tool provided to draw the circle.

3.Connecting Low Voltage Power & Video:

NOTE: Power and video can be connected before or after unit is mounted into the ceiling.

a.Prepare the low voltage wires by stripping 9-11 mm (0.39-inch) from each wire.The push-wire connector is designed to accommodate AWG 20-16 wire.

b.Connect the line and neutral wires.

c.Route and connect video cable to BNC connector.

4.Install box into pre-cut tile. Position the round section of the box in the direction that the camera will be aimed (see Figure 1).

Figure 2

6.Reinstall tile in grid.

7.Fasten support wire (not provided) to structural framing, masonry, or concrete above the unit. Connect the other end to the eyebolt in the top of the box. Draw wire tight and twist securely.

8.Adjust camera for proper viewing angle.

9.Assemble dome in the trim ring by lining the slots in the dome with tabs in the trim ring and pushing the sides of the dome under the tab.Turn the dome to secure it

(see Figure 3).

10.Attach the dome/trim ring by lining up the dots on the box and the trim ring. Push on one side of the trim ring near the flat section of the box, then push on the other side of the trim ring until it snaps into place. Listen for a distinct click to ensure ring is securely in place

(see Figure 3).

Dome

Trim Ring

Figure 3

Figure 1

5.Pull the drawstring tight (away from the screw) to clamp down on the ceiling, then lock the drawstring into the groove. Figure 2 shows the housing clamped to the ceiling. DO NOT CUT DRAWSTRING. Push the excess string through the hole provided.As an option, a screwdriver may be used to turn screws and lock ceiling clamps in place.

11.Adjust the dome so that the viewing slot is in the proper position.

5.2Hard Ceiling Mounting

Mount the unit in a hard ceiling, e.g. dry wall etc. as follows. Be sure the ceiling will support the weight of the housing and camera.

(continued on back cover)

6