CAMERA/LENS Settings | Sanyo Security Camera specs

5.2Hard Ceiling Mounting

Mount the unit in a hard ceiling, e.g. dry wall etc. as follows. Be sure the ceiling will support the weight of the housing and cam- era.

1.Cut a 172 mm (6.75-inch) diameter hole in the ceiling. Use two pencils (or a pencil and a nail) with the template tool provided to draw the circle.

2.Run electrical cabling to housing and make proper connec- tions (see Section 4.1 for details on power connections).

3.Install box into pre-cut hole. Position the round section of the box in the direction that the camera will be aimed (see Figure 3).

4.Pull the drawstring tight (away from the screw) to clamp down on the ceiling, then lock the drawstring into the groove. DO NOT CUT DRAWSTRING. Push the excess string through the hole provided.As an option, a screwdriver may be used to turn screws and lock ceiling clamps in place.

5.Adjust camera for proper viewing angle.

6.Assemble dome and trim ring as instructed in suspended ceiling mounting section.

100 0009 002 SAN 12/04

6 CAMERA/LENS SETTINGS

The camera and lens come factory configured and ready for operation. If custom setup is required, refer to the camera Installation Instructions included in the Instruction Manual Packet.

Sanyo Fisher Company

Security Video Division

21605 Plummer Street

Chatsworth, CA 91311 Tel: (818) 998-7322 Fax: (818) 717-2716

Technical Support: (888) 66SANYO

Printed in USA