ATTACHING THE FRONT COVER
The speaker and the front cover are packed separately. To attach the front cover, line up the six salients (magnet) on the reverse side of the front cover with the six corresponding pegs.
SPECIFICATIONS | |
Type | |
| speaker system |
| Magnetic shielding type |
Driver | 16 cm |
| 13 cm (5”) cone midrange |
| 3 cm (1”) aluminum dome tweeter |
Impedance | 6 Ω |
Frequency Response | 35 Hz to 50 kHz |
| to 100 kHz |
Nominal Input Power | 50 W |
Maximum Input Power | 200 W |
Sensitivity | 89 dB/2.83 V/m |
Crossover Frequency | 500 Hz, 5 kHz |
Dimensions (WxHxD) | 349 x 1051 x 487 mm |
| |
Weight | 27 kg (59 lbs. 8 oz.) |
•Specifications subject to change without notice due to product improvements.
•Care should be taken not to exceed the input power values noted above.
English
Notes
•When the cover is not attached, take care not to touch the speaker units with your hands or to exert excessive force with tools.
•There are magnets on the reverse side of the front cover. Do not place the front cover close to objects that might be affected by magnets, such as TVs, clocks, magnetic cards, diskettes etc. when you don’t use it.
Taking care of the speaker
When you wipe this unit, do not use chemical solvents (ex. alcohol or thinners etc.); this might damage the finish. Use a clean, dry cloth. For heavy dirt, dampen a soft cloth in detergent diluted with the water, wring it out, and then clean this unit up with a soft cloth.