Advanced operation
Troubleshooting tips
EN
Cut
You can erase unwanted parts from your recording.
1. | Select folder. | A |
2. | Select file. | AM |
3. | Start playback of |
|
the file with the | SP | |
unwanted part. |
| |
4. | Press ERASE to | A |
mark the start of | AM | |
the unwanted part, |
| |
SP | ||
display. |
| |
5. | Press ERASE to |
|
mark the endof the unwanted part,
6.Press ERASE again to confirm cutting (or press STOP to cancel)
7.“WAIT” will show on the display.
8.After the memory rearrangement completed, the unit will go to STOP mode.
Tip:
Cutting, inserting new
segments and adding appendix will only update
the recorded time length, without changing recording time and date.
Format (Caution! All data inside the memory will be erased)
You can format the internal memory when needed. (e.g. compatability problem, etc.)
The procedures are as follow:
1. | Turn on the unit. | A |
|
| |
2. | Press ERASE, “DELETE” |
|
| ||
| MM | DD | |||
will flash on the display. |
|
|
|
| |
3. | Press and hold REC for |
| ONE | DICT | |
3 seconds, “FORMAT” will |
|
|
| ||
| SP |
|
| ||
flash on the display. |
|
|
|
| |
4. | Press and hold ERASE, | A |
|
| |
“WAIT” will show on the |
| MM | DD | ||
display, formatting is in |
|
|
|
| |
process. |
| ONE | DICT | ||
|
|
| |||
6. | After the formatting is |
| SP |
|
|
|
|
|
| ||
completed, the remain time of the selected
memory will show on the display.
Unit doesn’t turn on
•Check that batteries are properly inserted and not exhausted.
•Make sure battery compartment door is properly closed.
•Make sure LOCK function is not activated.
Display keeps flashing when unit is off
•You may not have set the time. Refer to section on Time Setting.
Cannot record
•Make sure LOCK function is not activated.
•Make sure memory is not full.
•You have recorded 99 files in one folder. Try record in a new folder.
•If you select external memory, please ensure that an external memory card is properly inserted.
Cannot show recording date and time during playback
•You may have not set the date and time before recording. Refer to section ‘Time Setting’.
No sound from speaker during playback
•Make sure volume is not set to 0.
•Headphones should not be connected.
Cannot edit
•Make sure LOCK function is not activated.
Cannot activate the unit after pressing on keys
•There may be software problems. Remove the batteries to reset the unit.
Recordable time becomes shorter
•You may have set the recording quality to ‘High Quality’, refer to section ‘Setting Recording Quality’.
Cannot perform playback
•Make sure you have selected folder with recorded messages.
•Make sure LOCK function is not activated.
Cannot erase recorded file(s)
•Make sure you follow each step under section “Erasing Selected File” carefully.
Cannot stop recording when AVR ON
•If AVR ON sensitivity is too high (e.g.
8 - 10), recording may not be stopped in noisy environment.
Cannot keep the saved setting
•If the batteries are removed, saved settings may be removed.
EN
14 
15