Remote Control (continued)
Replace Remote Battery Cell
1.Turn the remote over. Insert a pencil or paper clip in the small hole and slide it in the direction of the arrow while removing the battery cell holder.
2.Remove the old battery by pushing it to the front and then up.
3.Insert the lithium cell into cell holder so its positive (+) terminal faces up.
4.Slide the holder back into the remote until it clicks into place.
Notes: Never place anything heavy on top of the remote or lay it upside down.
Replace the cell when the camcorder fails to respond to the remote.
Remove the cell from the remote if it will not be used for a month or more. This will prevent possible damage from leakage. If leakage occurs, wipe up the liquid inside the compartment, and replace the cell with a new one.
Cell
Cell Holder
Cell
Cell Holder
Cautions: Lithium cell battery. Replace only with
Keep out of the hands of children. Can cause death or injury if swallowed. If swallowed, consult a physician immediately for emergency treatment.
The lithium cell used in this device may explode resulting in a fire or chemical burn if mistreated. Do not recharge, disassemble, heat above 212˚F (100˚ C), or incinerate.
Never use metallic tweezers to hold the cell, and never short circuit the + and – sides of the battery.
18