RCA JOYTECHTM AV CONTROL CENTER 2 manual Contents

AV_CONTROL_V1_ENG.qxq 22/11/04 11:33 am Page 4

ENGLISH ENGLISH

Input Selector	Press to page through and select the required Input Channel
IR Remote Receiver	For use with the Remote Controller

Display Setting Controls These controls are used to program the Input Channel

	names displayed on the LCD Display
Input 6	Primarily used for temporary connection of camcorders and
	other AV devices to the AV Control Center 2
REAR VIEW
		AC 9V IN

Input 1 Input 2 Input 3 Input 4 Input 5 Output

The AV Control Center 2 has a total of 6 Input Channels. Input 6 is located on the front panel and Inputs 1 to 5 are located on the rear panel. Each Input Channel comprises of either 5 or 7 Input Connectors (figure.1)

CONTENTS

Figure 1.

Composite video (yellow)

Left Audio (white)

Right Audio (red)

S-Video

Optical Audio

SCART Ethernet

REMOTE CONTROLLER

You can page through each Input Channel by pressing the Select Button on the front

panel of the AV Control Center 2. Alternatively you can select each Input Channel by

using the Directional or Numerical Buttons on the Remote Controller.

The Standby Button located on the Remote Controller allows the AV Control Center 2 to be switched from on to standby mode.

Standby

Directional

Buttons

Numerical

Buttons

When inserting new batteries into the Remote Controller take care to observe the correct polarity.

Requires 2 x AAA (LR03) alkaline batteries.

EXAMPLE OF A TYPICAL SETUP USING THE AV CONTROL CENTER 2

The AV Control Center 2 has been designed to connect up to 6 separate AV devices and output the Audio/ Video signal to a single input on the TV / Hi-Fi. Each device can be selected independently of each other. Once a device has been connected there is no need to remove any of the cables when selecting an input. Figure 2 shows a typical AV set up using the AV Control Center 2.

Figure 2.

DVD Player satellite receiver VCR Xbox™ PlayStation®2

TV

stereo Hi-Fi

camcorder

NOTE: The devices connected in this illustration are for reference only. Any suitable device may be connected to the Input Channels.

4 5