Connections & Setup
+
+
O
Y
A
L
P
MENU dial
M
A
F
F
O
Y
A
LP
Power switch
Setting the Tape Length
You need to select the tape length so that the camera can alert you how much time you have left on the tape.
1.Set the Power switch to M (manual record). (The POWER indicator comes on.)
2.Press the MENU dial in. (The CAMERA MENU appears.)
3.Rotate the MENU dial to highlight TO SYSTEM MENU. Press in the MENU dial to select it. (The SYSTEM MENU appears.)
POWER indicator
STOP |
| R | RETAKE | F |
|
| |
| R/M |
|
|
| CHARGE | POWER REFRESH | EJECT |
COUNTER | FADE/WIPE |
|
| DIGIFECT |
|
| |
| P . | AE |
|
| |||
4.Rotate the MENU dial to highlight TAPE LENGTH. Press in the MENU dial to select it. (The TAPE LENGTH menu appears.)
5.Rotate the MENU dial to highlight the length of the tape you are using (T20, T30, T35, T40). (T20=20 minutes, T30=30 minutes, etc. in SP mode.) Press in the MENU dial to select it.
6.When finished, press in the MENU dial again to exit.
Note: The tape remaining time feature is accurate only if the correct tape length has been selected.
24 | Chapter 1 |