Calumet 750 manual Rear Control Panel, Side Control Panel, Operating Your Travelite

Control Panel Guide Connecting and Using Your Travelite

Rear Control Panel

Carry handle

Photocell On/Off

Model Lamp

Full/Proportional

Modeling Lamp

Control Switch

Sync Socket

Side Control Panel

Reflector

Release

Flash Power/

AC / Battery

Power Select

AC Inlet

Fuse (and Spare Fuse)

Battery Power Inlet

Photocell

Operating Your Travelite

The Calumet Travelite may be operated either on an AC supply or with a Calumet Travel-Pak

For AC operation, the AC switch (page 4) should be in the upper position I.

For battery operation the switch should be in the lower position II.

The center position is off.

NOTE: When operated from a battery source, the modeling functions are not available.

•Ensure the power source is off.

•Connect the unit using the appropriate cable.

•If using the Travel-Pak, ensure the connector locks are fully tightened.

•Switch the power source on, then switch on the Travelite.

•The unit will charge and indicate it is ready for use by illuminating the green flash-ready light.

•Press the test button to check the unit fires.

WARNING HIGH VOLTAGE! NEVER CONNECT THE TRAVELITE TO BOTH AC SUPPLY AND BATTERY SUPPLY AT THE SAME TIME. THIS APPLIANCE MUST BE GROUNDED WHEN USED WITH AC. DISCONNECT THE AC PLUG WHEN CHANGING MODELING LAMPS AND FLASH TUBES.

Mounting Your Travelite

Mount your Travelite on a dependable support system

The mount bushing on the L-bracket allows for two possible ways of mounting to the stand/support (RIGHT).

Method B may be found useful if the light is required to point down.

Model Lamp Control	Flash-Ready	Test/
	Indicator	Open Flash

A

B

4calumetphoto.com

calumetphoto.com 5