Light Modifiers
Page 2 of 2
Open the zipper on the bottom of the unit. Open the white diffuser panel. Place the mono light just inside of the light modifier (leaving the controls on the outside). Close the zippers around the light to create a snug fit. After the light is in place, close the diffuser panel by fastening the hook and loop tape. Use the handle of the mounting rod for easy light adjustment.
For indirect diffusion when using the Apollo™ Mono, purchase an optional Reflector Plate (style #2875). Remove the reflector from the light and extend the bare bulb of the mono light further up into the Apollo™ (still leaving the controls outside of the unit). The anodized aluminum reflector plate is mounted on the center shaft of the Apollo™ just in front of the flash tube. This allows the light to bounce off the reflector plate and around the inside of the light modifier before it is sent through the diffuser panel. The Reflector Plate can be adjusted along the shaft closer or further from the flash tube to control the amount of light that is reflected off the silver interior of the Apollo™ Mono.
Westcott Apollo™ styles that are available and
recommended wattage:
#2200 | Micro Apollo™ flash only |
#2218 | Mini Apollo™ 250W |
#2334 | 28” Recessed Front Apollo™500W |
#2335 | 28” Recessed Front Apollo™ Mono 500W |
#2348 | 50” Recessed Front Apollo™ JS 1000W |
Accessory for Apollo™ Mono
#2875 Internal Reflector Plate for Apollo™ Mono
Questions? Please call 800.886.1689 or email info@fjwestcott.com. | ©F.J. Westcott Company |