Socket Mobile IC-4088A Battery Charging, Battery caution, Recycling information U.S.A. only

Page 11
BATTERY PACK

BATTERY CHARGING 3

Battery caution

CAUTION NEVER short the terminals.

NEVER mix old and new batteries.

NEVER incinerate used battery cells. Internal battery gas may cause explosion.

Make sure all battery cells are the same brand, type and capacity.

AVOID over charging— The BP-202 can be charged during oper- ation when the AC adapter or the optional cigarette lighter cable is connected. To prevent over charging, the IC-4088A has charging timer that automatically disconnecting the charging line electroni- cally after 15 hours from charging. However, the charging timer will reset and start charging again when disconnect then re-connecting the AC adapter or CP-18A more than 1 min. interval.

Recommended temperature range for charging: +50˚F to +104˚F (+10˚C to +40˚C)

The optional BP-202includes rechargeable Ni-Cd batteries and can be charged approx. 300 times. Charge the battery pack before first operating the transceiver or when the battery pack becomes exhausted.

If the battery pack seems to have no capacity even after being fully charged, completely discharge it by leaving the power ON all day. Then, fully charge the battery pack again.

If the battery pack still does not retain a charge (or very little), a new battery pack must be purchased.

DRecycling information (U.S.A. only)

The battery (BP-202) that you have purchased is recyclable. At the end of its life, under various state and local laws, it may be illegal to dispose of this battery into the municipal waste stream. Call 1-800-822-8837 for battery recycling options in your area or contact your dealer.

2

3

5

Image 11
Contents I4088A Foreword Supplied Accessory Precaution Precaution Table of Contents BP-202 Alkaline cells Battery installationSpeaker Switches, controls, keys and connectorsPanel Description Channel UP Switch Y Volume Control VOLPTT Switch PTT Mode Switch Mode0TRANSMIT Indicator Appears during PTT on KEY Lock IndicatorGroup Number Indicator Channel Number IndicatorRecycling information U.S.A. only Battery ChargingBattery caution Regular charging with the BC-149A, CP-18A Charging connectionsAC adapter AD-105 BC-119N Not used IC-4088A BP-202 Turn the power OFFBasic Operation Power onAdjusting the volume Selecting the operating channel Receive and Transmit Talk Range Setting the group code Group Mode CtcssFreq Ctcss code tableStarting the scan Scan FunctionCall-Ring Ring FunctionsSmart-Ring Voice scrambler function Initial set modeEntering initial set mode Other FunctionsScan resume type Time-out timerAuto power OFF timer Beep tones ON/OFFLCD backlight Ring tone typeLock function ‘ Auto power saveATS Automatic Transponder System ‘ Resetting the transceiverOptional HM-75A functions Switch actionPTT switch Lock switch General SpecificationsCH Freq.MHz Channel number and group numberChannel frequency list HM-46/HM-75A/HM-131 Speaker Microphones OptionsMemo 6274D-1US- w