Maintenance
The Arrow 40/55 Fluid Head offers high quality surface | Illumination Button |
coatings, dust and moisture seals. Miller recommends |
|
keeping the Fluid Head clean at all times by using soft brushes |
|
and lint free cloth to wipe over the surfaces. |
|
◗ Do not immerse the Fluid Head in any liquid. |
|
◗ Do not use stiff brushes, abrasives, harsh detergents and |
|
solvents. |
|
Battery Replacement
The Arrow 40/55 Fluid Head uses a single GP23A type - 12 Volt battery for Illumination. Miller recommends the following batteries to provide long life performance – Duracell MN21/23, Eveready A23 or Vinnic L1028.
◗ Using a Phillips Head #1 screw driver, remove the two RETAINING SCREWs, BATTERY DOOR and the old battery.
◗ Insert the new battery as shown in figure 10.
◗ Insert the tab on the BATTERY DOOR into the body first then align the two screw holes and tighten the screws snugly.
Fig. 10 |
|
|
|
|
|
Battery |
| Retaining Screw |
| Battery Door |
9