Miller Camera Support 1025 manual Counterbalance Control, Counterbalance Performance

Operating Instructions

3. Counterbalance Control

The counterbalance system was designed to neutralise the effect of the camera weight when it is tilted. The Arrow 40/55 Fluid Head offers a 4 position counterbalance system which can be operated via the COUNTERBALANCE SELECTOR (fig. 1). The COUNTERBALANCE SELECTOR must be operated when the SLIDING PLATFORM is in a horizontal position. After changing the Counterbalance setting it may be necessary to tilt the camera back and forth to ensure that the CB spring has engaged. The camera must be held securely while changing the Counterbalance setting.

3.1For safety ensure that Counterbalance position 4 is selected.

3.2Hold the camera and release the TILT LOCK, then gently tilt the camera from a horizontal position forward then backward and observe its response. If the Camera ‘Springs Back’ to the horizontal position then a lower Counterbalancesettingisrequired,selectCounterbalance position 3 and recheck, select lower setting again if necessary. Correct counterbalance setting has been acheived when minimum effort is required to move the camera over the entire tilt range.

TIP Fine tuning can be achieved by adjusting the SLIDING PLATFORM – see step 2.6.

Counterbalance Performance

(mm)	300										Arrow 40
Plate	250
Camera	200
	150
above	100
of G	50
	0	2		4	6	8	10	12		14	16	18		20	22	24
C
	Fig. 7
						Camera Payload (kg)
(mm)	300										Arrow 55
Plate	250
Camera	200
	150
above	100
	50
of G
	0	2	4	6	8	10	12	14	16	18	20	22	24	26	28	30
C

Fig. 8 Camera Payload (kg)

7