Feed Belt Drive: Lubricate with lithium grease monthly. Wipe sawdust and dirt impregnated grease off of the chain and gears shown in Figures 28 & 29. Apply fresh lithium grease to the gears and chain.
Table Lift Mechanism: Lubricate the table lift screws, chain, and helical gear with lithium grease every six months. Clean the chain and table lift screws (Figure 30), then rub lithium grease onto the chain links and screw threads. Clean the heli- cal gear (Figure 31) and place a dab of grease on the teeth. Move the table up or down to spread the grease thoroughly throughout the mechanism.
Figure 28. Feed belt drive chain.
Figure 30. Table lift screws (only two shown).
Figure 29. Feed belt gears.
Figure 31. Helical gear.
Sanding Belts
You can greatly increase the lifespan of your sanding belts if you clean them often. Cleaning pads (Accessories on Page 24) are the fastest way to remove sawdust
G0458 18" Open End Belt/Drum Sander |
