Grizzly G0458 instruction manual Installing Sander on Stand, To install the sander on the stand

Installing Sander on

Stand

The sander is very heavy. DO NOT over-exert your- self while unpacking or moving your machine— get assistance.

Components and Hardware Needed:	Qty
Sander	1
Stand Assembly	1
Hex Bolts M8-1.25 x 20	4
Flat Washers 8mm	8
To install the sander on the stand:

1.Make sure the sander is still resting on the shipping pallet.

2.Place the pallet and stand near the perma- nent mounting location (once the sander is mounted to the stand it will be difficult to move).

3.With help of an assistant, tilt the sander back so the side with pulley cover faces the pal- let, move the left bottom edge of the sander forward, and rest the left side of the sander on the pallet as shown in Figure 8.

Note: The base should stick out a few inches beyond the edge of the pallet.

-14-

Figure 8. Sander tipped back on pallet against

pulley cover.

4.Place two stacks of blocks the same height as the pallet and about 15 inches apart on the floor near the sander base as shown in Figure 9.

Figure 9. Blocks set near sander base.

G0458 18" Open End Belt/Drum Sander