Additional Safety for Drum Sanders
1.FEEDING STOCK. DO NOT allow anyone to stand at the outfeed end when feeding your stock. Never sand more than one piece of stock at a time.
DO NOT jam the workpiece into the machine during operation. Firmly grasp the workpiece in both hands and ease it into the machine using light pressure.
2.MINIMUM STOCK DIMENSIONS. DO NOT sand any stock thinner than 1⁄8", narrower than 1⁄8", or shorter than 6". DO NOT sand thin stock by using a “dummy” board under your workpiece.
3.CLOTHING. DO NOT wear loose clothing while operating this machine. Roll up or button sleeves at the cuff.
4.HAND PROTECTION. DO NOT place hands near, or in contact with, sanding drums during operation. DO NOT allow fingers to get pinched between board and conveyor belt during operation. This may pull the operator’s hand into the machine and cause serious injury or death!
5.INSPECTING WORKPIECES. Always inspect workpiece for nails, staples, knots, and other imperfections that could be dis- lodged and thrown from the machine during sanding operations.
6.DUST COLLECTION SYSTEM. Never operate the sander without an adequate dust collection system in place and run- ning.
7.UNATTENDED OPERATION. Never leave the machine running unattended.
8.REPLACING SANDING PAPER. Replace sanding paper when it becomes worn.
9.EXPERIENCING DIFFICULTIES. Any problem, with the exception of convey- or belt tracking that is concerned with any moving parts or accessories, must be investigated and corrected with the power disconnected, and after all moving parts have come to a complete stop.
10.MAINTENANCE AND ADJUSTMENTS. Never attempt to adjust conveyor belt track- ing when the sanding drums are engaged. Perform machine inspections and main- tenance service promptly when called for. Disconnect power before performing main- tenance or adjustments on the sander.
11.RESPIRATOR AND SAFETY GLASSES. Always wear a respirator and safety glass- es while operating the machine. Dust and chips are created when sanding. Some debris will be ejected, becoming hazards to the eyes and lungs.
Like all machines there is danger associated with this machine. Accidents are frequently caused by lack of familiarity or failure to pay attention. Use this machine with respect and caution to lessen the possibility of operator injury. If normal safety precautions are overlooked or ignored, serious personal injury may occur.
No list of safety guidelines can be complete. Every shop environment is different. Always consider safety first, as it applies to your individual working conditions. Use this and other machinery with caution and respect. Failure to do so could result in serious per- sonal injury, damage to equipment, or poor work results.
G0458 18" Open End Belt/Drum Sander |
