Sanding Tips

Replace the sandpaper with a higher grit to achieve a finer finish.

Raise the table a maximum of 14 turn of the handwheel until the workpiece is the desired thickness.

Reduce snipe when sanding more than one board of the same thickness by feeding them into the sander with the front end of the sec- ond board touching the back end of the first board.

Feed boards into the sander at different points on the conveyor to maximize sandpaper life and prevent uneven conveyor belt wear.

DO NOT sand boards less than 6" long or less than 18" thick to prevent damage to the workpiece and the drum sander.

Extend the life of the sandpaper by regularly using a PRO-STICK®sanding pad (Page 24).

When sanding workpieces with irregular sur- faces, such as cabinet doors, take very light sanding passes to prevent gouges. When the drum moves from sanding a wide surface to sanding a narrow surface, the load on the motor will be reduced, and the drum will speed up, causing a gouge.

DO NOT edge sand boards. This can cause boards to kickback, causing serious personal injury. Edge sanding boards also can cause damage to the conveyor belt and sandpa- per.

When sanding workpieces with a bow or crown, place the high point up (prevents the workpiece from rocking) and take very light passes.

Feed the workpiece at an angle to maximize stock removal and sandpaper effectiveness, but feed the workpiece straight to reduce sandpaper grit scratches for the finish pass- es.

G0458 18" Open End Belt/Drum Sander

Choosing Sandpaper

There are many types of sanding belts to choose from. We recommend Aluminum Oxide for gen- eral workshop environments. Below is a chart that groups abrasives into different classes, and shows which grits fall into each class.

Grit

Class

Usage

 

36

Extra Coarse

Rough sawn boards,

 

 

thickness

sanding,

 

 

and glue removal.

60

Coarse

Thickness

sanding

 

 

and glue removal.

 

 

 

 

80–100

Medium

Removing

planer

 

 

marks and initial finish

 

 

sanding.

 

120–180

Fine

Finish sanding.

The general rule of thumb is to sand a workpiece with progressively higher grit numbers, with no one grit increase of more than 50. Avoid skipping grits; the larger the grit increase, the harder it will be to remove the scratches from the previous grit.

Ultimately, the type of wood you use and your stage of finish will determine the best grit types to install on your sander.

-21-

Page 23
Image 23
Grizzly G0458 instruction manual Sanding Tips, Choosing Sandpaper, Grit Class Usage