Maintenance
The Compass 20 Fluid Head offers high quality surface coatings. | Battery Housing | Illumination Button | |
Miller recommends keeping the Fluid Head clean at all times by |
|
| |
using soft brushes and lint free cloth to wipe over the surfaces. |
|
| |
• | Do not immerse the Fluid Head in any liquid. |
|
|
• | Do not use stiff brushes, abrasives, harsh detergents |
|
|
| and solvents. |
|
|
Battery Replacement
The Compass 20 Fluid Head uses a single 11A type - 6 Volt battery for Illumination. Miller recommends the following batteries to provide long life performance – GP11A, Duracell MN11 or Vinnic L1016.
1 Using a Phillips Head #1 screw driver, remove the RETAINING SCREW and the BATTERY DOOR.
2 Using a small flat screw driver remove the battery.
3 Align the new battery as shown on the back of the BATTERY DOOR and place into the BATTERY HOUSING, then push down the battery into place. A small flat screw driver may be used to push down the battery into the
BATTERY HOUSING.
4 Align the BATTERY DOOR into the body then tighten the screw lightly.
Retaining Screw | Battery Door | Battery |
Fig. 8
9