the <string> position. The maximum length of <string> is 255 characters.
3)sysName=<string>
Set the instance of
4)enaAuthTraps=<value>
Set the instance value of
5)community=<ID>,<rwAttr>,
<communityName>,<IpAddressString>
Set the community name and the reading/writing attributes. <ID> describes the setting identification number (1 to 8), <rwAttr> describes a character representing the reading/writing attribute (“r”, “R”, “w or “W”), <communityName> describes the community name to be set, and <IpAddressString> describes the IP address of the host you allow the access (0.0.0.0 for any host).
Example: To allow reading/writing any host in the “private” community and having the ID number “2”.
community=2,w,private,0.0.0.0
6)trap=<ID>,<communityName>,
<IpAddressString>
Set the host you want to send traps to. <ID> describes the setting identification number (1 to 8), <communityName> describes the community name to send traps to, and <IpAddressString> describes the IP address of the host to send traps to. Example: To specify the destination of traps as the
private community and the ID number “1”. rap=1,public,196.168.0.101
7)delcommunity=<ID>
This parameter is used to delete the previous community setting. <ID> describes the community setting identification number (1 to 8).
8)deltrap=<ID>
This parameter is used to delete the previous setting of the host to send traps to. <ID> describes the trap setting identification number (1 to 8).
When you have finished changing the SNMP setting information, check the changed settings using an inquiry command. If the changed settings are OK, restart the SNMP using the following CGI command. Be careful that by entering the command, the camera enters the restart mode.
SNMP restart command <Method>
GET, POST <Command>
http://ip_adr/snmpdconf/snmpdconf.cgi? snmpd=restart
Others
Using the SNMP
47