Sharp VL-Z5E operation manual General Symptom Possible cause Suggested solution

Appendix

General

Symptom	Possible cause	Suggested solution
Remote control does	REMOTE menu item is set to “OFF”.	Set REMOTE menu item to “ON”
not function.		(p. 46).
	Remote control battery has run	Replace remote control battery with
	down.	new one (p. 13).
	Remote control used beyond oper-	Use remote control within operating
	ating range.	range (p. 46).
	Intense daylight falling on	Protect remote sensor from expo-
	camcorder remote sensor.	sure to intense daylight (p. 46).
	Obstacle between remote control	Remove obstacle or use remote
	and camcorder remote sensor.	control from different angle (p. 46).
“E007” is displayed	The camcorder may be damaged.	Do not take out a cassette, and call
on the screen, and		for service.
unable to operate
normally.

Notes:

•This unit is equipped with a microprocessor. Its performance could be adversely affected by external electrical noise or interference. If this should happen, turn off the power and disconnect the unit from any power sources, including the lithium battery, etc. Then reconnect the power sources to resume operation.

•If the characters displayed in the viewfinder or on the LCD monitor screen appear to malfunc- tion, disconnect the power source and remove the lithium battery, then reconnect the power source, insert the lithium battery, and turn the power on again. The characters on the monitor should be normal. Set the date and time, then resume operation.

Appendix

100