Care and Maintenance
General Use
Location
Cleaning
Turn the scanner off before disconnecting the power.
Always write down the programmed frequencies in the event of memory loss.
If memory is lost, simply reprogram each channel. The display shows 000.0000 in all channels when there has been a memory loss.
Always press each keypad button firmly until you hear the entry tone for that key entry.
If strong interference or electrical noise is received, relocate the scanner or its antenna away from the source of the noise.
If possible, a higher elevation, may provide better reception. Also try changing the height or angle of the antenna.
Do not use the scanner in
Avoid placing the unit in direct sunlight or near heating elements or vents.
Do not plug the scanner into an outlet controlled by a wall switch as prolonged periods without power will cause scanner memory loss.
Disconnect the power to the unit before cleaning.
Clean the outside of the scanner with a mild detergent.
To prevent scratches, do not use abrasive cleaners or solvents. Be careful not to rub the LCD Display window.
Do not use excessive amounts of water.
33