32
Looping Outputs
The 8/16 Channel DVSe has up to 16 looping outputs. Depending on the destination of the looping outputs, each one may have to be terminated.
CH 1 in | CH 2 in | CH 3 in | CH 4 in | CH 5 in | CH 6 in | CH 7 in | CH 8 in | CH 9 in | CH 10 in | CH 11 in | CH 12 in | CH 13 in | CH 14 in | CH 15 in | CH 16 in |
CH 1 Out | CH 2 Out | CH 3 Out | CH 4 Out | CH 5 Out | CH 6 Out | CH 7 Out | CH 8 Out | CH 9 Ou t | CH 10 Out | CH 11 Out | CH 12 Out | CH 13 Out | CH 14 Out | CH 15 Out | C H 16 Out |
The 32 Channel DVSe has up to 32 looping outputs. Connect the included 16 Channel BNC Connector Cables to the 16 Channel Cable Adapter ports.
|
|
|
|
| O | N |
|
|
|
|
|
| O | F | F |
| B | N | C |
| A |
|
|
|
|
|
|
| O | N |
|
|
|
|
|
| O | F | F |
CO NROLT | B | N | C |
| B |
|
|
|
|
|
|
|
|
| |
CO M |
| 1 |
| 2 | 3 | 4 |
|
S E N S O R
The video inputs/outputs are 75 Ώ BNC connectors. Make sure there is a video source connected to the input and then connect a cable to the Channel Out on the BNC Connector Cable. The looping outs can be connected to video monitors or combined with adapters to connect to VCRs.
Looping Output Termination
When it is necessary to terminate a looping output, the recorder has built in termination that allows users to select individual outputs. It is not always necessary to terminate the output; it depends on the device to which you are connecting. As a rule, if the image appears distorted or virtually unviewable, it likely needs to be terminated.
ON | Not connected to a monitor (Normal) |
OFF | Connected to a monitor (Looped) |
Always leave the dipswitch set to the ON position when the Looping Outputs are not used.