33
Connecting a PTZ Camera
Setting up a PTZ Camera is simple. The recorder comes preassembled with an internal PTZ adapter. The cabling may be run up to 4,000 ft using 22 Gauge Twisted Pair.
It is important to understand how the PTZ connects to the recorder. The recorder outputs an
Attaching the 4-Pin Adapter
1.Locate the PTZ adapter cable
2.Connect the wires of the PTZ adapter to the PTZ camera. The yellow wire should connect to the RX+ on the camera and the orange wire should connect to the
3.Connect the other end of the adapter to the XVR unit as shown.
4.Assign the PTZ camera an ID number in PTZ Setup that coincides with the number assigned to the camera. This is normally done utilizing a
Example: If the camera is plugged into input number 5, set the PTZ unit to ID number 5.
Signal Line (+)
Signal Line