6-2 Installing to Wall
The camera head at shipping is set for installing the camera to the ceiling. The camera head angle should be changed when installing to a wall.
2
"Bottom" Mark
Camera Head
1
Tilt Range
(1) Turn 2 screws of 1 to unfasten the camera head.
Note :
•The camera head is connected to the inside with cable, do not pull it with strength. Otherwise the inner connector may be broken and the image may not appear.
(2)Reverse the camera head 180° from default setting and install it. The direction of the camera head is shown as above. With the “Bottom” mark2 upwards, the tilt range is adjusted as shown above.
(3)Fasten the screw 1 to fix the camera head.
6-3 Installing the Cover
As shown in the illustration, adjust the cover position to the camera’s installation position and turn it right to install it.
- 8 -