Status LED
The LED indicates the status of the Network Camera.
Item | LED status | Description | |
1 | Red LED steady ON | Power on and system booting | |
Red LED OFF | Power off | ||
| |||
2 | Steady Red + Blink Green every 1 sec. | Network works (heartbeat) | |
Red LED Steady ON + Green LED OFF | Network fail | ||
| |||
3 | Blink Red every 0.15 sec. + Blink Green every 1 sec. | Upgrading F/W |
4Blink Red every 0.15 sec. + Blink Green every 0.15 sec. Restoring default
Hardware Reset
The reset button is used to reset the system or restore the factory default settings. Occasionally resetting the system can return the camera to normal operation. If the system problems remain after resetting, restore the factory settings and install again.
Reset:Hold for about 3 seconds and release the recessed reset button. Wait for the Network Camera to reboot.
Restore:Press and hold the recessed reset button until the status LED rapidly blinks. It takes about 10 seconds. Note that all settings will be restored to factory default. Upon successful restore, the status LED will blink during normal operation.
Restoring the factory defaults will erase any previous settings.
14