Toshiba IK-WD04A user manual Status LED

Page 14

Status LED

The LED indicates the status of the Network Camera.

	Item	LED status	Description
	1	Red LED steady ON	Power on and system booting
	1	Red LED OFF	Power off
		Red LED OFF	Power off
	2	Steady Red + Blink Green every 1 sec.	Network works (heartbeat)
	2	Red LED Steady ON + Green LED OFF	Network fail
		Red LED Steady ON + Green LED OFF	Network fail
	3	Blink Red every 0.15 sec. + Blink Green every 1 sec.	Upgrading F/W
	4	Blink Red every 0.15 sec. + Blink Green every 0.15 sec. Restoring default

Hardware Reset

The reset button is used to reset the system or restore the factory default settings. Occasionally resetting the system can return the camera to normal operation. If the system problems remain after resetting, restore the factory settings and install again.

Reset:Hold for about 3 seconds and release the recessed reset button. Wait for the Network Camera to reboot.

Restore:Press and hold the recessed reset button until the status LED rapidly blinks. It takes about 10 seconds. Note that all settings will be restored to factory default. Upon successful restore, the status LED will blink during normal operation.

Restoring the factory defaults will erase any previous settings.

14

Image 14

Contents Model IK-WD04A Table of Contents Page Introduction FCC USA-INFORMATIONTerms Important Safeguards AttachmentsLightning Field Installation Marking Do not aim the camera at the sun Precautions for Use DisclaimerPackage Contents Physical Description General I/O Terminal Block Status LED SD/SDHC Card and Capacity Setting up the Network Camera over the Internet InstallationHardware Installation Network DeploymentInternet Software Installation Ready to Use Accessing the Network Camera Using Web BrowsersPage Using Rtsp Players Using 3GPP-compatible Mobile Devices MPEG-4Main Host NameConfiguration Area Resize ButtonsResume button Video Title Client Settings MP4 Saving Options Configuration System General settings SystemSystem time General settings System Homepage layoutTheme Options Palette window will pop up as shown below System log Log server settingsSystem Logs Access log System ParametersGeneral settings Reboot System MaintenanceGeneral settings Upgrade firmware General settings Restore Import/Export filesPage Page Manage Privilege Root PasswordSecurity User Account Manage UserCreate and Install Certificate Method Security Https Hypertext Transfer Protocol over SSLHttps Page Page Page Security Access List Filter Administrator IP address Delete Allowed/Denied listSecurity Ieee Protected LAN Network General settings Network TypePPPoE Point-to-point over Ethernet Error Router does not support UPnP port forwarding Page Enable IPv6 Http//20010c08250000020202d1fffe0465f4 Port Network Streaming protocols Http streamingRtsp Streaming Page Page Network QoS Quality of Service Requirements for QoSQoS/DSCP the DiffServ model Ddns Dynamic domain name service Network DdnsSnmp Configuration Network Snmp Simple Network Management ProtocolVideo Image Day/Night Settings Preference Page Exposure Include Exclude Privacy mask Advanced Mode Stream settings Video StreamParameters of the multiple streams Page Page PTZ PTZ settings Digital PTZ Operation E-PTZ OperationHome page in E-PTZ Mode 2012/10/12 Event Event settings EventPage Page Add server Page Page Page Add media Snapshot20111015100341 Video20111015100341 Format is HH 24r Page Page Applications Motion detection Check Enable this profile Page Applications Digital input Applications Tampering detectionRecording Recording settings Recording Settings100 NAS server 102 103 SD card control Local storage SD card managementSD card staus Search Results Local storage Content managementSearching and Viewing the Records Click to adjust the image size Troubleshooting Reset and restoreSpecifications AWB109 Appearance Diagram Technology License Notice Preamble 113 114 No Warranty END of Terms and Conditions Trademarks Toshiba America Information SYSTEMS, INC