Front panel/Rear panel

LOW

HIGH

LINE

1 2 3 4 5

1LOW control

This control knob enables you to adjust the bass in the range of –3dB to +3dB based on a reference value of 100Hz. The bass range is ﬂat with the knob set at 12 o’clock, boosted when the knob is turned clockwise, and cut when the knob is turned counter-clockwise.

2HIGH control

This control knob enables you to adjust the treble in the range of –3dB to +3dB based on a reference value of 10kHz. The treble range is ﬂat with the knob set at 12 o’clock, boosted when the knob is turned clockwise, and cut when the knob is turned counter-clockwise.

3Power indicator

This indicator lights up green when you turn the POWER switch on the rear panel ON.

4LINE 1 level control

This control knob enables you to adjust the volume level of the signal input at the INPUT LINE 1 jack (7) on the rear panel. Turning the knob counter-clockwise lowers the volume level, and turning it clockwise raise the level.

5LINE 2 level control

This control knob enables you to adjust the volume level of the signal input at one of the INPUT LINE 2 jacks (8) on the rear panel. Turning the knob counter- clockwise lowers the volume level, and turning it clock- wise raises the level.

6	8	7
POWER
	ON	INPUT
	ON
		LINE 1
		(–10dB)
	OFF
		LINE 2
		(+4dB)
		PARALLEL

6POWER switch

This switch turns the power to the MSP3 on and off. When you turn this switch on, the power indicator (3) lights up green.

7INPUT LINE 1 jack

This input jack is used to connect an RCA pin plug.

8INPUT LINE 2 jacks

These balanced jacks are used to connect an XLR-3-31 type connector or a TRS phone plug to input line-level signals from a mixing console.

CAUTION

TO PREVENT ELECTRIC SHOCK,

MATCH WIDE BLADE OF PLUG TO

WIDE SLOT, FULLY INSERT.